Logo

For threading small wire that is curling or has difficulty holding a straight shape you can use a soda straw.

Steps :

1. Insert your material in the straw until you can see the material exit the other end.
2. With the machine unplugged, push the lever down and hold it open while inserting the straw into to feed hole.
3. Insert the straw/material until you see it coming through (out the exit shoot) and pull the straw out leaving the material where you see it coming out the machine.
4. Plug the machine back in and program the length and quantity you need and push run. The first chop will cut off the material hanging out the machine, then your machine will begin the measure and cut process.

Tips :

• When cutting material smaller than .200�? OD use the white inlet guide that comes with your unit. Go to www.automaticwirecutter.com to see more about the Wire Cutter II

Warnings :

Make sure you have taken the straw out of the machine before you begin operation.